E
54
Changing the lamp bulbs
Before replacing a burnt-out bulb, check that the new one
complies with voltage and wattage specified in the
“Electrical System” paragraph on page 72.
Headlamp(fig. 48, fig. 49, fig. 50, fig. 51)
To carry out maintenance on the headlamp, it is
advisable to remove the dome cover as described in the
“Removing the dome cover” paragraph on page 44.
To access the headlamp bulbs, loosen the lower screw (1)
that attaches the rim/reflector assembly to the body.
Detach connector (2, fig. 49) from the headlamp bulb.
Release the clip (3, fig. 49) retaining the bulb and remove
it from the mounting.
3 2
fig. 49
1
fig. 48
To Next Page