E
41
Seat catch and helmet hooks
Opening (fig. 29)
Fit the ignition key into the lock (4) and turn the key
clockwise about 1/4 turn until the rear end of the seat lifts
up. Pull the seat backwards to slide it off its front holders
(1).
On the rear end of the compartment underneath the seat,
there is the helmet fastening cable (2) (see page 65). Insert
the cable into the helmet and insert the ends of the cable
into one of the two hooks (3). Leave the helmet hanging
outside (fig. 30) and refit the seat.
Warning
This system is intended to lock your helmet safely
when you park your motorcycle. Never leave the helmet
hanging from the hook when riding or it may get in the way
and make you lose control of the motorcycle.
Closing
Make sure that all parts are arranged and secured properly
inside the compartment under the seat. Slide the front
ends of the seat bottom underneath the frame U-bolt and
push down on the rear end of the seat until you hear the
catch click. Make sure the seat is firmly secured to the
frame and take the key out of the lock.
2
3
fig. 30
0
0
1
1
O
P
E
N
C
L
O
S
E
4
1
fig. 29
To Next Page
Loading...
