SECTION 3 | INSTALLATION
403-618-03 Infinity™ Series Servo Ultrasonic Press Systems User Manual
20
System Inputs/Outputs Signal Descripons on the J5 Connector
Pin 17 Programmable Output Status J5 Pin 17 (Servo Error)
This output is acve for the following alarms:
Pin 18 Programmable Output Status J5 Pin 18 (In-Cycle)
Pin 19 (Ultrasound Status Output)
Pin 20 (Any Fault Status Output)
Generator faults that will acvate the Any Fault output:
Over Temp Fault
Pin 21 (Overload Status Output)
Pin 22 (Bad Part Status Output)
been detected.
Pin 23 (Good Part Status Output)
suspect or bad part has been detected.
Pin 24 (Ready Status Output)
Pin 25 (Top of Stroke Status Output)
Pin 26 (Isolated Output Common)