Dukane Infinity Series - Aligning Fixture to Horn (All Models)

403-618-03 Infinity™ Series Servo Ultrasonic Press Systems User Manual
59
SECTION 4 | TOOLING SETUP
Figure 4-87


1. 
2. Ensure the E-STOP is released, then start up the system normally.
3. 
a. For Trigger Type, select Force.
b. 
4. 

5. 

6.                     

7. 
8. 
the parts.
9. 

this step.
10. 
11. 
a. 
b. 
c. 
Aligning the Fixture (for all models)