Soft Serve Freezer Model GES-102
184559 27
c. the spigot o-ring grooves, nozzles,
the shaft cup seals, plastic
washers and o-rings as shown in
gure 8-8.
d. the air bleed plug o-ring grooves
e. the beater shaft and the scraper
blade pin holes, as shown in
gure 8-9.
Important:
Do not leave parts in sanitizer for
longer than 15 minutes.
3. After all parts are washed and, rinsed,
place them in the sanitizing solution.
For proper sanitizing, the parts must
remain fully immersed in the sanitizer
for 5 minutes. Allow the parts to air-
dry after sanitizing.
4. The following must be thoroughly
brushed rst with a warm dish
detergent solution, then rinsed with
clear water followed by the sanitizing
solution.
a. mix feed tubes from the refrigerated
cabinet to the cylinders as shown in
gure 8-11
8.3 Cleaning Instructions (continued)
Figure 8-9 Scraper Blade pin holes
Figure 8-11 Brush inside of cylinder mix feed tubes
Figure 8-10 Clean Cylinders
.
To Next Page