1.11 CLEANING EXTREMELY DIRTY FLOORS
When it is necessary to thoroughly wash floors with ingrained dirt it is advisable to switch off
the “mop-up”.
In such conditions the water left on the floor will serve to further soften the dirt and this will be
subsequently removed by an energetic brushing action together with the steam.
To deactivate the recovery device, proceed as follows:
1.
Stop the machine (if in operation);
2.
Position the MOP-UP lever (figure “1.10”) upwards.
Then, by positioning the MOP-UP lever downwards the automatic dirty water recovery system
will be switched back on.
IMPORTANT!
When using this procedure on carpets extra care must
be taken not to soak the floor.
USING THE STEAM AND STEAM PLUS MODELS
1.
Press the main switch on the boiler (A) (figure “1.16”).
The switch will ligh t up when the
handle is moved into a working
positio n .
2.
Slowly lower the handle on one of the sides. The
machine will start up and the revolving brushes will
start revolving on the floor.
3.
As the machine is moved over the floor the steam
generator will start to heat up, after about 1 minute
steam will start to flow from the stainless steel
plate on the side of the tank.
4.
Operate the lever positioned under the handle
every time that floor needs additional wetting.
5.
Move the machine forwards following the same washing
track.
6.
Dispense the liquid by activating the lever underneath the
handle at brief intervals and only when the machine is moving
forwards, taking care not to flood the floor.
A
Figure
1.16
1
To Next Page
Loading...
