1.16 CLEANING AND MAINTENANCE OF THE BRUSHES
DUPLEX brushes require little routine maintenance.
The high rotation speed during cleaning helps to dislodge dirt and keep the brushes efficient
at all times.
However, check their status and clean them regularly.
WARNING
Remove the plug from the power socket before cleaning the brushes.
In addition to cleaning, it is necessary to perform the following operations daily:
1.
Remove the brushes from the machine (see following section);
2.
Dip them in a container with cold or lukewarm water and let them soak for a few hours;
3.
Stir and rinse the brushes well;
4.
Re-fit the brushes in the reverse position in relation to the one they had before (point 1).
This is necessary as the bristles tend to bend when the brushes always rotate in the
same direction.
TO REMOVE THE BRUSHES
1.
Use the supplied allen key to remove the two screws on the stainless side panel (1).
2.
Extract the two brushes together with the side panel (2).
3.
Separate the two brushes from the side panel.
1
2
Figure 1.20
To Next Page
Loading...
