CLEANING FLOORING WITH WAX CLEANERS
The Duplex machine can wash and polish certain types of flooringfor an optimal “polished look”
and instantaneous recovery of the dirt in a simple, fast manner.
It is extremely suitable for the following floor types:
• Terracotta
• Smooth tiles
• Marble
• Granite
• Industrial flooring
• Studded rubber flooring
Proceed as follows:
1.
Use the machine with the two grey brushes;
2.
Fill the two water tanks with the appropriate detergent (see Duplex
recommendations) mixing it with water according to the instructions contained on the
bottles;
3.
Proceed with the usual washing system.
At the end of washing we recommend passing over the surface using the Brown polishing
brushes to obtain a polished look.
Extremely dirty floors:
Whenever it is necessary to wash floors which have remained dirty for a long time with all sorts
of stains and the build-up of solvents from normal detergents, it is recommended to switch off
the `mop up`.
In this way the liquid on the floor will be scrubbed into the surface and will allow it to work for
longer, thus allowing the detergent to be more effective.
Proceed as follows:
1.
Stop the machine (if in operation);
2.
Position the MOP-UP lever (figure “1.10”) upwards;
3.
Press the lever of the handle to dispense a large amount of detergent consisting of product/
water, preferably warm (35/40°C) .
4.
Move the machine forward on the entire wet surface, in all directions or following precise
tracks;
5.
When work is complete stop the machine;
6.
Move the MOP-UP lever downwards to re-activate the automatic dirty water recovery device.
7.
Proceed with the usual washing system.
WARNING
The MOP-UP lever must only be activated when the machine is
stopped. Thoroughly clean the machine and brushes after
cleaning very dirty
floors and before cleaning delicate floors.