WARNING
Do not use worn and/or deformed brushes that could cause
vibrations. In this case contact the Service Department.
CLEANING THE MACHINE
1.
Remove the three tanks (figure “1.21”).
2.
Use a damp sponge to carefully clean the
rubber conveyor belts and every part of the
machine;
3.
Use a brush to remove every residue of dirt
from all the corners of the machine.
4.
Dry well.
Figure 1.21
WARNING
Never use pressure washers to clean the machine.
CLEANING THE TANKS
The t a n k s for dirty water m u s t be removed
from the machine and may be with running water.
Make sure that there is no dirt and/or foreign
bodies preventing the valves located inside the
tanks from closing.
1.
unscrew the screws (1);
2
2.
remove the nozzles (2) from the tanks holding
them in the middle and pull them upwards;
Figure 1.22
To Next Page
Loading...
