1.12 TIPS FOR CLEANING FLOORS
The original DUPLEX brushes are tested and balanced individually with special electronic
instruments and guarantee the absence of vibrations that could generate mechanical stress for
the machine and the floors.
The brushes are supplied in different colours according to their use characteristics:
All-purpose for all types of flooring (standard supply)
All-purpose for hard floors.
For very heavy scrubbing.
Used singly in conjunction with a standard black brush.
For cleaning carpets
How to clean carpets:
Set the slide switch to the working position, choosing the correct
operating position (normal carpets / long-pile carpets). It is
recommended to cross over the washing tracks in order to thoroughly
wash all the fibres while taking care not to wet the carpet too much.
(Make several trial runs before proceeding with the full washing
operation).
Polishing brushes for polishing smooth surfaces.
After spreading a thin layer of liquid wax evenly over the floor
wait until the wax is completely dry.
Then vigorously brush the floor with the dry brown brushes
.
Only for fine polishing and endowing waxed and very smooth
floors with a mirror finish.
Extremely abrasive for removing paint, plaster, incrustations
of cement and other products, even when dried hard on resistant
industrial floors: these brushes can normally be used with water and
detergents.
CAUTION: due to their abrasive power they may damage
the floor.
To Next Page
Loading...
