1.18 TROUBLESHOOTING TIPS
WET STRIPES ON THE SIDES
• Excessive liquid dispensed
• Irregular paths are covered failing to follow the instructions on paragraph “1.10 HOW TO
WASH FLOORS”.
• Recovery tank trimmers dirty or worn. Replace.
The dirt is not picked up
• Mop-Up device turned off.
• Worn brushes.
• Recovery tank trimmers dirty or worn out.
• Cleaning liquid not coming out.
• The recovery tank has not been fitted correctly into its housing.
Does not start up
• Faulty plug.
• Mains cable damaged (DO NOT USE).
• “Motor protector“ tripped. Press the (MP) button to re-activate it, “1.8 STARTING UP”.
Resetting occurs after about 60 seconds.
• The slide switch 1 has been left in the “RT” (rest translation) position “1.8 STARTING UP”.
• The handle has been lowered too quickly.
• Voltage too low.
It vibrates
• The brushes are deformed, worn or dirty, follow the instructions on paragraph “TO
REMOVE THE BRUSHES”.
Liquid flows continuously
• The pistons sticking out of the frame too far, in this case they restrict the tanks which cannot
be removed and as a result the valves remain open.
• Pull the lever on the handle several times in order to facilitate the unblocking. Otherwise
introduce a screwdriver or a piece of wood into the opening of the tank and press on the
rubber valve so that is pushes the pistons backwards.
To Next Page
Loading...
