2-18
12H-M12M0-0309-0
(9) Buzzer ON/OFF setting (Code No.9)
Mode for setting ON/OFF the buzzer which sounds during key operations, when a process ends, or when errors
occur. Can be set to “ON” or “OFF”.
At shipment, this is set to “ON”.
A warning buzzer sounds when motor problems occur even if this setting is set to “OFF”. (It will not sound
when errors such as paper jams, etc. occur.)
NoteNote
(10) Power still ON alert setting (Code No.10)
Mode for setting the time to sounding a buzzer to alert that the power is still ON when the unit is not used. Can be
set to “OFF” (buzzer not sounded), “5 MIN”, “15 MIN”, or “30 MIN”.
At shipment, this is set to “OFF”.
(11) Speed 1 adjustment (Code No.11)
Mode for setting the folding roller speed when processing speed is set to 1. Can be set to “NORMAL” or “SLOW”.
At shipment, this is set to “NORMAL”.
When folding thin and flimsy paper, folding problems may occur if the processing speed is set to 1. In such cases,
set to “SLOW”.
The speed of processing speed 1 when set to “NORMAL” is about 460 mm/s. Setting to “SLOW” lowers
the speed to about 290 mm/s.
When set to “SLOW”, the processing speed 1 LED blinks.
When set to “SLOW” and firm paper is used, the main motor may lock due to load.
NoteNote
(12) Processing speed adjustment (Code No.12)
Mode for finely adjusting the speed when the processing speed does not satisfy the specifications
(200 sheets/minute in single folding of B4 paper, 255 sheets/minute in single folding of letter size paper
for USA). Can be set to “NORMAL”, “FAST”, or “SLOW”.
At shipment, this is set to “NORMAL”.
When the EEPROM is initialized, it is set to “NORMAL”.
(13) Operation mode setting (Code No.13)
Mode for setting the operation mode of the unit. Can be set to “OFF”, “LAST TIME FOLD”, or “STOPPER FIXED”.
At shipment, this is set to “OFF”.
+5%
–1%
+5%
–1%
When set to “STOPPER FIXED”, after exiting the maintenance mode, be sure to press the clear key while
pressing the stop key to perform initialization. Initialization is not carried out even if the power is turned
OFF and then ON again. Using the unit without performing initialization may result in incorrect
operations.
The operation mode can be set without entering the maintenance mode. (Refer to the instruction manual.)
NoteNote
(14) Total counter (Code No.14)
Displays the total number of sheets fed into the machine.
(15) MC ROM version display (Code No.15)
Displays the program version of the microprocessor of the MC unit.
(16) OP ROM version display (Code No.16)
Displays the version of the OP unit.
(17) Paper ejection cover detection ON/OFF setting (Code No.17)
Mode for turning the paper ejection cover detection ON/OFF. Can be set to “ON” or “OFF”.
At shipment, this is set to “ON”.
(18) Program version up mode (Code No.18)
Mode for upgrading the program version.
“7. UPGRADING THE PROGRAM VERSION”
SeeSee
To Next Page
Loading...
Need help?
General
