Duplo DocuCutter CC-228 - Setting Up Procedure; Paper Width Adjustment; Paper Loading and Tray Pressure

Page 11
SETTING UP PROCEDURE
1
To set the width of paper,
loosen thumbscrew knob
on the side guide and slide
to position. Use marking
as reference point.
2
Fan paper before loading.
This will reduce static and
toner adhesion due to
printing. For best result,
the paper stack should be
flat.
3
Push the feed tray down
and load the paper.
Readjust paper guide if
needed.
4
Adjust tray pressure. For
thinner paper, the number
should be higher. For
heavier paper the number
should be lower.
Thumbscrew knob
Paper feed guide
Markings