To Next Page
M
Marie MaldonadoAug 22, 2025
What to do if my Duplo Cutter has no power?
- LLeonard HallAug 22, 2025
If your Duplo Cutter has no power, check the fuse, the power plug, and ensure that the power board has a 5V and 36V output.
What to do if my Duplo Cutter has no power?
If your Duplo Cutter has no power, check the fuse, the power plug, and ensure that the power board has a 5V and 36V output.
Why is my Duplo Cutter miss feeding?
If your Duplo Cutter is miss feeding, you should check the S1 voltage, feed motor belt, pulley screw, and motor detent torque. If there is no torque, consider replacing the driver board.
What to do if there is a jam in Sensor 2 of my Duplo Cutter?
If there is a jam in Sensor 2 of your Duplo Cutter, you can try the following: * Check S2. * Adjust the feed tray tension. * Adjust the ramp. * Check that the transport motor has detent torque.
What to do if there is a jam in Sensor 3 of my Duplo Cutter?
If there is a jam in Sensor 3 of your Duplo Cutter, you should check S3 and the detent torque of the transport motor. If there is no torque, consider replacing the driver board.
What to do if the finish card length is uneven on my Duplo Cutter?
If the finish card length is uneven on your Duplo Cutter, adjust the cutter Assy. frame mounting screw on the side plates and check the driving belt tension.
How to fix mark error on Duplo Cutter?
To fix a mark error on the Duplo Cutter, check the mark sensor voltage, ensuring it sees paper at 0.2V and a mark greater than 1.8V. You may also need to change the mark sensor and perform a top margin calibration.
What to do if finish card is not clean and neat on Duplo Cutter?
If the finish card is not clean and neat on your Duplo Cutter, adjust the cutting knife guiding plate. If the problem persists, replace the cutting knife.
What to do if my Duplo Cutter shows 'Check Top Cover'?
If your Duplo Cutter shows 'Check Top Cover', inspect the top cover interlock switch.
What does it mean when my Duplo Cutter says 'Check Rear Cover'?
If your Duplo Cutter displays 'Check Rear Cover', examine the rear cover interlock switch.
What to do if my Duplo Cutter displays 'Check Waste Bin'?
If your Duplo Cutter displays 'Check Waste Bin', check the waste bin interlock switch.
General| Cutting Speed | Up to 40 cuts per minute |
|---|---|
| Power Supply | 120V, 60 Hz |
| Dimensions | 20.9" (L) x 17.3" (W) x 11.8" (H) |
| Weight | 44 lbs |
| Cutting Width | 228 mm |
| Maximum Cutting Width | 228 mm |
| Maximum Cutting Height | 15 sheets (80 g/m²) |
