6. Operation Procedure
6.1 Load the Paper
6.1.1 Press , the feed tray will be lowering down to home position
6.1.2 After the paper is loaded, press to bring the stacker up to ready position
6.2 Adjust the Jogger Clapping Plate Home Position
6.2.1 Loosen the clapper locking thumb knob and put aside the clapper to the side.
6.2.2 Feed one piece of paper throught coater and into stacker
6.2.3 Set the clapping plate against the sheet and keep 0.5~1mm spacing.
6.2.4 Press again to change to “OFF” mode
6.2.5 Press to set stacker to “Ready” mode
6.3 Setting the Clapping Cycle
6.3.1 Press to change mode from “READY” to “OFF”
6.3.2 Hold gently then press to set every 1, 2, 3, 4, 5 or 6 pieces the clapper will
activate one time to organize the stacking pile.
6.4 Setting the Back Stop
.
To Next Page
Loading...
