Duplo DPC-600PKG - Reset Counter; Error Code

- 80 -
7. Reset Counter
7.1 Press to change to “OFF” mode.
7.2 Press and tip on
8. Error Code
Error
Code
Sensor
No
Symptom and Possible Cause
Action
E001
S1
Jogger sensor error
Call for service
E002
S2
Paper jam at S2
1 Correct skew, readjust side guide
2 Check media not flat or curled
3 Sensor #2 dirty
4 Remove the paper
E003
S2
Input sensor see no paper.
Input sensor failed
E004
S4
Level sensor keep seeing paper
1 Readjust side guide
2 Check media quality
3 Check side guide and clapping plate
alignment
4 Check and adjust end stop setting
E005
S4
Level Sensor Error
1 Check stacking tray position
2 Check end stop position
3 Level sensor failed
E009
S4
Stacking Upper Limit Switch Error
Level sensor failed, call for service
E009
S7
Top margin Limit Error
Top margin sensor fail, call for service
E010
S8
Bottom Limit Error
Bottom margin sensor fail, call for service
- - - -
S9
Top Margin
Feed Tray up to top margin
- -
S10
Bottom Margin
Feed tray down to bottom margin
Blinking
“□□□□”
Press doesn’t feed
1. Coater not ready
Error
can not
be reset
1. Exit sensor sensed the Infra Red
2. Paper path has paper
1.Try to cover the sensor to block the Infra
Red
2. Remove the sheet in paper path
No
Power
E-stop is ON
Reset E-stop