Duracell POWERPACK300 User Manual

Recharging the Duracell® Powerpack Battery
~ CAUTION
Do not operate AC or DC appliances while the Duracell®
Powerpack
is being recharged with the DC charging cable from
your vehicle.
To recharge the Duracell® Powerpack while you drive
using the DC charging cable:
1. While the vehicle engine is running, plug one end of the
DC charging cable into a DC power outlet on the
Duracell® Powerpack.
2. Plug the opposite end of the DC charging cable into the
vehicle's lighter socket or
12 V accessory outlet.
3. Once the Duracell® Powerpack is fully charged or
if
your vehicle's engine is not running, disconnect the DC
charging cable from both sockets.
Most
of the Duracell® Powerpack's capacity will be
restored in 2
~ hours while the vehicle engine is running.
Note: The Battery Level LEDs are only accurate when the
Duracell® Powerpack has been disconnected from all appliances
and all charging sources for
15 minutes.
Important:
Do not leave the Duracell® Powerpack permanently connected to
the vehicle's lighter socket or
12 V accessory outlet.
Do not solder or hard wire the DC charging cable from the
Powerpack to an external electrical system. The charging cable
is
designed for temporary use only to recharge the Powerpack
battery.
• • •• • __ .. _ •• • __ ._ •• • •• ••••• __ •• _~ •••• _ •• __ M ~ •• _ •• _._~_ ••• _~ .~ •• v __ ._. • • •• __
31

Duracell POWERPACK300 Specifications

General

Brand	Duracell
Model	POWERPACK300
Category	Portable Generator
Language	English