5. Filling with oil
(until July 2003) (from August 2003)
Top up the oil reservoir only with DA-10 oil or an equivalent oil with the following
specification:
–
Viscosity at 40° C : 10 mm
2
/s
–
Flash point: 150 °C
DA-10 can be obtained from DÜRKOPP ADLER AG sales outlets
(see operating manual, page 27).
–
Remove oil-filling screw 1 and pour in oil.
–
Check oil level at sight glass 2.
The oil level must be between “FULL” and “EMPTY”.
–
Replace oil-filling screw 1.
Clean up any oil overflow.
GB
11
1
2
1
To Next Page
Loading...
