PAGE - 2
Key
Parameters Function Range Pre.setting Description
HVP -20 Parameters List for DA-251 (MAC. 35)
Parameters
Code
Additional 15 stitches are added to the Start and End back-tacking stitches function selection.
ON：Valid.
OFF：Invalid.
0. Depends on the pedal.
1. At motor stop.
2. At trimming after .
3. At trimming after & at motor stop.
29 SB9 0-99 stitches plus on Start/End back-tacking 0 - 99 stitches 0 Additional setting stitches are added to the Start and End back-tacking stitches.
Added 1 stitch to the C segment of End back-tacking function selection.
ON：Valid
OFF：Invalid
Bar-tacking mode selection.
A：One shot sewing.
M：Pedal control and motor can stop at middle way.
SU：One shot sewing but motor stops at needle up by 【027. CT】 timer at end of each seam.
SD：One shot sewing but motor stops at needle down by 【027. CT】 timer at end of each seam.
Valid only when the operation panel disconnected.
ON：Perform
OFF：Not perform.
33 BRC Setting stitches of Bar-tacking 0 - 99 stitches 4
One setting for all seams , 【032. BAR】 = ON valid.
34 BRN Setting turns of Bar-tacking 0 - 15 times 4
Setting the seam times of Bar-tacking , 【032. BAR】= ON valid.
35 BT5 Stitch balance for Bar-tacking 5 4 BT5=0 : Invalid,1-8 : Increase stitches of reverse seam; 9-F : Increase stitches of forward seam.
36 BT6 Stitch balance for Bar-tacking 6 3 BT6=0 : Invalid,1-8 : Increase stitches of forward seam; 9-F : Increase stitches of reverse seam.
Constant-stitch sewing mode selection.
A：One shot sewing.
M：Pedal control and motor can stop at middle way.
Valid only when the operation panel disconnected.
ON：Perform.
OFF：Not perform.
Setting stitches for section 1 ～4 of Constant-
stitch sewing
15
Stitches setting of seam P1-P4. 【038. PM】 =ON valid.
Setting stitches for section 5 ～D of Constant-
stitch sewing
0
Stitches setting of seam P5-PD. 【038. PM】 = ON valid.
P
O
W
E
R
..
O
N
39 PS 0 - 250 stitches
A/M/SU/SD31
15 stitches plus on Start/End back-tacking
(with C60)
ON/OFF
Mode selection for foot lifting .
(with F-10)
30
SMB
AFM
Mode selection for Bar-tacking
00/1/2/3
A
BCC
Added 1 stitch to the C segment of End back-
tacking
ONON/OFF
OFFON/OFF
0 - F
A/M
OFF
MMode selection for Constant-stitch sewingSMP37
Bar-tacking selectionBAR32
28
SB5
Constant-stitch sewing selectionPM38 OFFON/OFF
From the library of: Diamond Needle Corp
To Next Page
Loading...