12
(2). When use with C-60 operation box :
Function KEY Operation of Sewing Machine
Double start back tacking (A,B sections)
Single start back tacking (A,B sections)
Half start back tacking (B section )
Double end back tacking (C,D sections)
Single end back tacking (C,D sections)
Start / End
back tacking
selection
Half end back tacking (C section)
Constant stitch
sewing
1). As the treadle is toed down, constant-stitch sewing E、F、G or H
performed section by section.
2).Once the treadle returns to neutral intermediately in any one
section, the machine will stop immediately. When the treadle
toeing down again, the balanced stitches of E、F、G or H goes
on.
3).If the parameter【010. ACD】is set ON, the machine will not stop
and automatically start trimming cycle and end back tacking at
the end of the last section E or H.
4).When using P1~PF function, P1~P4 default setting is 15
stitches, other unused sections must set 0 stitch.
Free sewing
1).As the treadle is toed down, machine will start sewing. Once the
treadle returns to neutral, machine will stop immediately.
2).As the treadle heeled back, the trimming cycle will be finished
automatically.
EF
G
SP
H
ACBD
From the library of: Diamond Needle Corp
To Next Page
Loading...