13
Bar tacking
As the treadle is toed down, all the seams of bar tacking, A、B、C、
D sections will be completed with E times, and the trimming cycle
will be finished automatically
Note：When the bar tack sewing start, it will not stop until the
trimming cycle finished, except for the treadle heeling back to
cancel the action.
Stitch setting
selection
A、B、C、D -- stitch setting range in 0
~ F (Note)
E、F、G、H -- stitch setting range in 0
~ 99
----
A=B=C=D=4 stitches
----
E = F = 10 stitches
----
G = H = 15 stitches
∴ Press key to select : Top A、B、C、D
Middle E、F
Bottom G、H
Needle up / Forward
stitch correction
1).In free sewing:
One touch of this key act as stitch correction. (half stitch forward)
2).In constant-stitch sewing：( In Bar-tack sewing, it act as needle up )
a. If sewing stops intermediately in one section, one touch of this
key will raise the needle to up position.
b. If sewing stops at the end of section, one touch of this key will
correct one stitch forward.
One-shot sewing
( AUTO )
1). In free sewing and bar-tack sewing：
One touch of this key makes beep sound but no function; also LED
does not light up.
2). In Constant-stitch sewing：
a. One shot to the pedal, automatic performed number of stitches
of E、F、G、H sections.
b. Toeing down the pedal again to finish the rest sections until it
finish pattern.
Trimming cycle
selection
Enable or disable the trimming cycle.
A B C D
1 0 1 0
E F
G H
1 5 1 5
E F
G H
A B C D
4 4 4 4
E F
G H
A B C D
From the library of: Diamond Needle Corp
To Next Page
Loading...
Need help?
General
