14
Slow start
1).When function is turned ON, slow start activated at first
run of motor start. After trimming, it will activate again on
next
motor start.
2). Speed of the slow start can be set by parameter [007. S].
3). Number of stitches can be set by parameter [008.SLS].
Needle up / down
when motor stop
Needle stop setting
LED ON= Stop at UP position
LED OFF=Stop at DOWN position
Presser foot up / down
after trimming cycle
Presser Foot action after trimming
LED ON= Automatic lift the presser foot after trimming
LED OFF=Presser foot not active after trimming..
Presser foot up / down
when motor stop
Presser foot action when motor stop
LED ON=Motor stop, presser foot goes up automatically.
LED OFF=Presser Foot not active when motor stop.
Value / Parameter
increment key
A、B、C、D section value increment key, range in 0~ F.(Note)
E、F、G、H section value increment key, range in 0~99.
Value / Parameter
decrement key
A、B、C、D section value decrement key, range in 0~ F.(Note)
E、F、G、H section value decrement key, range in 0~99.
Enter parameter area /
Parameter increment
Press and hold this key for 2 second to enter parameter area.
Also act as parameter increment key
Enter parameter value /
Saving
Press this key in parameter area to enter parameter value area.
Also act as the parameter value saving key.
Note : Stitches setting of A、B、C、D sections correspond to the alphabet.
A=10、B=11、C=12、D=13、E=14、F=15 stitches
From the library of: Diamond Needle Corp
To Next Page
Loading...