Owner's Guide
6
Part: XXXXX Rev XX
CAUTION
Important Safety Information
Do not drink water that has been inside the
unit for an extended period of time. Do not
drink the rst use of hot water from the
unit in the morning.
Do not disassemble the remote controller.
Do not use benzene, oil or fat detergents
to clean the remote controller.
Do not splash water on the remote
controller. Do not expose the remote
controller to steam.
Do not locate the remote controller near stoves or
ovens, this may cause damage or failure.
Preventing damage from freezing (
p.22)
Damage can occur from frozen water within the
device and pipes even in warm environments.
Be sure to read below for appropriate measures.
Repairs for damage caused by freezing are not
covered by the warranty.
Do not get the remote controller wet.
ECB1D and ECB2D are water resistant,
too much water can cause damage.
ECM1D is not water resistant.
Do not install the equipment where the
exhaust will blow on walls or windows.
Treat hard, acidic or otherwise impure
supply water with approved methods to
ensure full warranty coverage.
Problems resulting from scale formation
are not covered by the warranty.
Do not run water through the unit when
unit is not on.
Power must be switched on at all times for
antifrost protection to work.
If it is snowing, check the air inlet, exhaust
gas vent and exhaust vent terminal for
blockage.
Do not use parts other than those speci ed
for this equipment.
Clean the lter on the water inlet as
frequently as required. The quality of your
local water will affect the frequency required.
Keep the area around the unit clean.
If boxes, weeds, cobwebs, cockroaches etc. are in
the vicinity of the unit, damage or fire can result.
When discharging hot water, make sure the unit is ON.
If water is run through the unit with the unit
OFF, water may condense inside the unit and cause
incomplete combustion or damage to the internal
electrical components.
This may cause deformation.
To Next Page
Loading...
