Owner's Guide
14
Part: XXXXX Rev XX
1
Press the Operation
Button
MAIN
ECM1D
2
1
(Main Controller)
(Starting with the Operation Off)
Setting and Using the Water Heater
The temperature will be
displayed on the Remote
Controller.
ON
Previous set temperature
(Eg.: 40°C)
DANGER
High Temperature
To prevent scalding:
Remote Controller Display
Hot Water Heater temperatures over 50°C can cause
severe burns instantly or death from scalding.
• Children, disabled and elderly are at the highest risk of being scalded.
Feel water temperature before bathing or showering.
Temperature limiting valves are available, ask licensed installer.
• When setting the unit to 60°C or more (
p.15), the temperature
display will flash for 10 seconds.
• Take caution when using the unit again after setting to 50°C
or higher. Always check the set temperature before use.
Flashing for 10 sec
ON
To Next Page
Loading...
