Installer’s Guide
Electric Boosted Solar
24
H3163 025247 Rev. C
• Fit the solar tempering valve that is
included with this water heater.
Note: Any adjustment
to the valve should be
made according to the
valve manufacturer’s
recommendations.
• When the power is turned on, the
Hotlogic will go through initialisation:
Sensors (red) and Power (green)
status lights will alternate for 4
seconds.
• After the initialisation, if there are no
red status lights visible on Hotlogic,
the system is functioning normally.
• If there are any red status lights
visible, refer to the Owner’s Manual
for a full list and description of
possible errors.
Hot
Tempered
Cold
To Next Page
Loading...
