DynalinkXDL-WRX36 | FAQ & Troubleshooting
41
Anonymous)
3. Go to WebGUI > Security > VPN > VPN client, select VPN type to OpenVPN. Select the OVPN file from
your OpenVPN Server and click Upload.
4. Enter Username and password if the OPENVPN server use username/password. If you would like to get all
Internet traffic to go through VPN, please select Yes on Enable Default Router. Click Apply when finished. You
can also add some description for your own reference.
5. After you finished the OpenVPN client set up and apply the setting. You will see this VPN client setup below.
Just click the Activate and you can activate this VPN tunnel.
To Next Page
Loading...
