To Next Page

To Previous Page

12 CC 222/222C - CC 232/232C - CC 322 M222EN5

EVERY 10 HOURS OF OPERATION (Daily)

Sprinkler system/Wheels

Checking - Cleaning

Scrapers

Checking - Setting

Fig. 12 Tire scrapers

1. Scraper blade

2. Cotter pin

3. Limit stop

Fig. 13 Tire scrapers

1. Scraper blade

2. Cotter pin

Fig. 11 Wheel rack

1. Rear water tank

2. Sprinkler nozzle

Fill the rear tank with emulsion fluid; for example, water

mixed with 2% cutting fluid. Make sure that the sprin-

kler nozzles (2) are not clogged. Clean them and the

filter if necessary. See under Sprinkler system/Drum;

Check - Cleaning, for detailed instructions.

Fluids that are flammable or detrimental to

the environment may not be used in the

emulsion tank.

Inspect the tire tread now and then to detect

asphalt compound that has fastened. This is

likely until the tires are sufficiently warm.

Make sure that the scrapers are undamaged. Adjust the

scrapers so that they lie 1–2 mm (0.04-0.08 in) from the

tires. For special asphalt compounds, it may be better if

the scraper blades (1) lie lightly against the tires.

The scrapers must hang freely from the tires during

transport driving. Lift up the scraper blades (1) and

latch them in the raised position with the cotter (2).

CAUTION

WARNING

1-2 mm

(0.04-0.08 in)

Dynapac CC 222 User Manual

Questions and Answers: