Dynapac CC 222 User Manual

22 CC 222/222C - CC 232/232C - CC 322 M222EN5
EVERY 500 HOURS OF OPERATION (Every three months)
Engine pre-filter - Change
Push the parking brake knob.
Switch off the engine and open the left door of the
engine compartment.
Release the hose clamps (2) with a screwdriver.
Discard the pre-filter (1) in a safe manner, it is
of the expendable type and cannot be cleaned.
Fit a new pre-filter and tighten the hose clamps again.
Start the engine and check that the pre-filter does not
leak.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors. Risk
of carbon monoxide poisoning.
Fig. 38 Diesel engine
1. Pre-filter
2. Hose clamps
2
1
2
Engine - Oil change
The engine oil drain plug is located adjacent to the
battery behind the left door of the engine compartment.
Run the engine warm before draining the oil.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors (risk
of carbon monoxide poisoning).
Switch off the engine and apply the park-
ing brake.
Place a receptacle that holds at least 15 liters
of under the drain plug. Save the oil and de-
posit it in an approved manner.
Danger of being burned when draining hot
oil. Protect your hands.
Unscrew the oil drain plug (1). Allow all of the oil to
drain off and refit the plug.
Fill with fresh engine oil; see Lubricant specification or
the engine manual for the correct grade of oil.
Check the dipstick to ensure that the engine oil level is
correct; see the engine manual for details.
12
Fig. 37 Engine compartment, left side
1. Oil drain
2. Battery
WARNING
WARNING
WARNING
WARNING

Dynapac CC 222 Specifications

General

Brand	Dynapac
Model	CC 222
Category	Construction Equipment
Language	English