2017-11-22 4812325556EN 27
When trying to turn on the machine without having set up to
three necessary conditions to do so, the missing ones are
shown in the display. The missing conditions must be set before
turning on the machine.
Conditions that must be set:
- The parking brake shall be activated.
- The forward/reverse lever shall be in the neutral position.
- The Diesel engine rpm shall be in the low speed (low = slow
speed) (not all the models, refer to the manual to know if your
model fits in this condition).
Operator help when activating
When trying to activate the edge cutter (option) with the
machine in high speed, the display will show the slow speed
mode for a few seconds.
To activate the previous function, make sure the low speed
mode is activated.
To Next Page
Loading...
