Dynapac CP1200 - Preventive Maintenance - Symbols and Lubricants

Preventive maintenance - Symbols and lubricants
2017-11-22 4812325556EN 53
Preventive maintenance - Symbols and
lubricants
Always use high quality lubricants and in the
amounts required.
Too much grease or lubricant oil can cause
overheating and premature wear.
ENGINE OIL
Room temperature: 5 F to 122 F (-15ºC to
50ºC)
Shell Rimula R4 L 15W-40 or equivalent.
HYDRAULIC OIL
Room temperature: 5 F to 122 F (-15ºC to
50ºC)
Room temperature: above 122 F (50ºC)
Shell Tellus V68 or equivalent.
Shell Tellus V100 or equivalent.
BIOLOGICAL HYDRAULIC OIL
When leaving the plant, the machine may be
filled with biologically degradable oil. When
replacing or filling with oil, use the same type
of oil used previously.
PANOLIN HLP Synth 46
(www.panolin.com)
GREASE
Shell Retinax LX2 or equivalent.
FUEL
Refer to the engine manual instructions.
-
COOLANT
Antifreeze protection effective down to -34.6
F (-37ºC). 50/50 mixed (clean water +
coolant additive).
GlycoShell/Carcoolant 774C or
equivalent.
For room temperatures extremely high or low, other
lubricants shall be applied.
Refer to the chapter "Special Instructions" or contact
DYNAPAC.