Dynapac CP2700 - Control Panel System Status Warnings; Hydraulic, Air, Battery, and Temperature Warnings

Instrument/controls - Description and function
26 4812325557EN 2018-02-19
Control panel – Alarms (cont.)
SYMBOL
DESCRIPTION
FUNCTION
Warning symbol, hydraulic oil filter.
If the symbol appears with the engine in
maximum rpm, it shall be necessary to
replace the hydraulic oil.
Warning symbol, air filter.
If the symbol appears with the engine in
maximum rpm, it shall be necessary to
clean or replace the air filter.
Warning symbol, battery charging.
If the symbol appears with the engine
running, the alternator is not charging.
Stop the engine and find the fault.
Warning symbol, engine temperature.
If this symbol appears, the engine is too
hot. Stop immediately the engine and find
the fault. Refer also to the engine
manual.
Warning symbol, hydraulic oil
temperature.
This symbol appears when the hydraulic
oil is too hot. Do not drive the roller, put
the engine on idle, wait until the oil cools
down and find the fault.
Warning symbol, low fuel level.
This symbol appears when the fuel level
is 10%.
Warning symbol, low sprinkler water
level.
This symbol appears when the sprinkler
water level is 10% in the main tank.
Warning symbol, low braking capacity.
This symbol appears when the oil level
and/or pressure for the brakes are low. If
this alarm appears and remains with the
machine working, stop it immediately and
contact DYNAPAC.