16
LT800 ILT800EN3
73
L000183B
1. Move the throttle to the working mode and the
tamper will begin to move.
During operation, the engine must always
work at full throttle (working mode).
Stopping the engine
1. Throttle in idle position. Let engine run a few minutes.
2. Throttle in stop position.
2. Guide the tamper with guide handle.
3. Take care that the shoe hits parallel to the ground.
4. Do not fight or overpower the machine.
Never work on hard surfaces (solid rock,
hardened concrete or such). When wor-
king in trenches always make sure that they
are wide enough. When working in a nar-
row trench, it the ramming shoe should get
caught between the walls of the trench, the
rammer may mis-strike and can be severely
damaged. The ramming shoe may especial-
ly be damaged severely. Make certain that
the rammer is steared only by using the
hand grip. It should only be pushed. The
rammer must not be pressed into the mate-
rials being compacted. Excessive pressure
to the operation handle will lead to the
unsatisfactory compaction due to the fact
that the jumping action is hindered. If the
machine falls over while working, switch
off the engine before raising it.
3
Stop
Working mode
Start
Stop
Working mode
Start
L000192A
OPERATION
2
L000191B
L000185B
2
1
Operating
To Next Page
Loading...