Dynapac LT800 - Troubleshooting

24
LT800 ILT800EN3
Insufficient fuel
Air filter is dirty
Motor oil low
Silencer is clogged
Gasket is leaking
Motor oil low
Restricted air flow
Clutch damaged
Broken connection rod or
crankgear
Broken pinion or clutch drum
Clutch damaged
Oil or grease on clutch
Soil buildup on ramming shoe
Broken or worn springs
Fill with gasoline
Clean/replace the air filter
Fill with motor oil
Clean silencer
Change gasket
Refill with lube oil
Clean/replace the air filter
Repair or replace clutch
Replace
Replace
Repair or replace clutch
Dismantle and remove oil/grease
Clean shoe
Replace springs
TROUBLE POSSIBLE CAUSE REMEDY
Engine stalls or does not start
Engine does not accelerate, is
hard to start or runs erratically
Engine overheats
Engine runs, but rammer does
not tamp
Engine runs, but rammer erratic
TROUBLESHOOTING