● Press and hold the key for 3 seconds to turn on the scan mode of the currently operation band
(CTRL). Repeat above procedure to turn off the scan mode.
● In standby mode, press the [MENU] knob and this key to select the scan mode for the current
operation band (CTRL).
>> Search (SE).
>> Carrier (CO).
>> Time (TO).
(5) [SQL/MONI] key:
● Press this key to set the squelch (SQ) level of the currently operation band (CTRL).
● Press and hold the key for 3 seconds to turn off the SQ circuit of the currently operation band
(CTRL) and be in monitor mode.
● Press the [MENU] knob, then this key to disable or enable RX/TX of the currently operation band
(CTRL).
(6) [TONE/T.SEL] key:
● In VFO mode, press this key to turn ON/OFF the CTCSS/DCS code of the current operation band
(CTRL).
>> Options: QT → DQT → OFF.
● If CTCSS/DCS is on, press and hold the key for more than 3 seconds to set the CTCSS/DCS code
of the current operation band (CTRL). RX, TX and RX + TX CTCSS/DCS code can be set
separately.
● In VFO mode, press the [MENU] knob, then this key, the currently operable band (CTRL) is
switched between VHF and UHF.
(7) [B/E] key:
● In menu operation, press this key to return to the previous operation.
● In any submenu operation, press and hold this key for more than 3 seconds to exit the operation
mode and return to standby mode.
● In standby mode, press and hold this key for more than 3 seconds to turn ON/OFF the key lock
function.
(8) [LED] indicator:
● Lights green when receiving and lights red when transmitting.
● When the speaker microphone is operated, the led flashed red.
(9) [PTT/CRL] key:
● Press this key to transmit in the selected band where you want to transmit, the selected band is
indicated by the “PTT” icon.
● Press and hold this key for more than 3 seconds to select the currently operation band (CTRL) for
any operation, including SQ level, volume, signaling, menu, etc. The selected band is displayed
with the “CTRL” icon.
● Press the [MENU] knob, and then this key to turn ON/OFF the display and working mode of the
non-operation band. The display switches between single band and dual band.
To Next Page
Loading...
