Fixing the Volume
You can set the speaker to a higher volume using the function to fix the volume. This setting also remains in eect
in standby mode. If a signal source is connected to the Xeo 10/20/30 with its own volume control, you have the
option to change the output volume across a broad range with the signal source.
To fix the volume:
▪ Point the remote control at a speaker and press for at least 2 seconds. To undo fixing, press one of the two volume
buttons.
Standby
To switch speakers to sleep mode:
▪ Point the remote control at a speaker and press or press on top of one of the speakers.
▪ The speakers will enter sleep mode.
▪ The speakers also enter sleep mode if there is no audio signal for 20 minutes.
▪ In this mode, the wireless network is active and all connected units remain synchronized.
▪ Sleep mode power consumption is <2 W.
To switch speakers to low-power standby mode:
▪ Press and hold on the remote control for at least 5 seconds.
▪ The speakers go to low-power standby mode.
▪ In this mode, the wireless network is disabled and the speakers are not connected to each other.
▪ Low-power standby mode power consumption is <0.5 W.
To turn o auto standby:
▪ Press and hold
on the remote control for at least 5 seconds.
Fixing the Volume 17
To Next Page
Loading...
