Dynisco 1480 - Rear Terminal Wiring

From lab to production,
providing a window into the process
-4-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
Rear Terminal Wiring
Connecons
All connecons to the device must be made through a spade format or similar
connecon, with connecon to the spade terminal touching both the insulaon and
conductor material. (Use a standard crimping tool). Connecons must be
mechanically secured so as to prevent any wiring becoming loose and coming in
contact with other wires or the instrument casing.
The above applies to any and all connecon to hazardous mains supply either
direct or indirect (Through a switch (Relay)) USE COPPER CONDUCTORS (EXCEPT
FOR T/C INPUT) Use Screened Cable on Retransmission Opon 1 Single Strand wire
gauge: Max 1.2mm (18SWG)
This diagram shows all possible opon combinaons. The actual connecons
required depend on the opons ed.