Dynisco 1480 - Setup Mode

From lab to production,
providing a window into the process
-9-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
4. Setup Mode
Note: Conguraon must be completed before adjusng Setup parameters. First select Setup
mode from Select mode (refer to secon 2). Press to scroll through the parameters (while this
key is pressed, and for 1 sec aer, the parameter legend is shown, then the current value). Press
or to change the value. To exit from Setup mode, hold down and press to return
to Select mode. Note: Parameters displayed depends on how instrument has been congured.