Dynisco 1480 - Configuration Mode

From lab to production,
providing a window into the process
-6-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
3. Conguraon Mode
First select Conguraon mode from Select mode (refer to secon 2). Press to scroll through
the parameters. While this key is pressed, and up to 1 second aer, the parameter legend is shown,
followed by the current value. Press or to set the required value. Press to display YES?
,press accept the change, otherwise parameter will revert to previous value. To exit from Con-
guraon mode, hold down and press , to return to Select mode. Note: Parameters
displayed depends on how instrument has been congured. Refer to user guide (available from
your supplier) for further details. Parameters marked * are repeated in Setup Mode.