Dynisco 1480 - Select Mode

From lab to production,
providing a window into the process
-5-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
CAUTION: Check informaon label on housing for correct operang voltage before
connecng supply to Power Input. Fuse: 100 – 240V ac – 1amp an-surge 24/48V ac/
dc – 315mA an-surge
Electrical shock can result in death or serious injury. Avoid contact with the leads and
terminals. High voltages that may be present on leads can cause electrical shock
Note: At rst power-up the message Goto ConF is displayed, as described in secon 6 of this
manual. Access to other menus is denied unl conguraon mode is completed
2. Select Mode
Select mode is used to access the conguraon and operaon menu funcons. It can be accessed at
any me by holding down and pressing . The SLCt legend is shown for 1 second, followed by
the legend for the current mode. Press or to choose the required mode, then press to
enter. An unlock code is required to prevent unauthorised entry to Conguraon, & Setup modes.
Press or to enter the unlock code, then press to proceed.
NOTE: Automac return to Operator Mode aer 2 minutes without key acvity.