Fitting notes
Service manual
46
114 Carefully prise the microswitch
cam and spring out of the neck.
115 When fitting the spring, ensure
the tail of the spring locates into
the channel in the microswitch
cam.
116 Locate the pillar on the cam into
the hole in the side of the neck.
Locate the ring on the end of the
spring over the thin pillar in the
neck ensuring the tail of the
spring remains retained within
the cam channel. Twist the cam
into position.
Test the Actuation of the cam
against the microswitch.
Fit the stow neck cover and two
short screws.
To Next Page
Loading...
