Service manual
Fitting notes
146 Locate the front of the brushbar
actuator into the top of the
brushbar motor cover.
Force the rear of the actuator
into the cover
Turn the floor tool over and
locate the lip of the actuator
over the ledge in the underside
of the brushbar motor cover.
147 Ensure the brushbar microswitch
loom is correctly located within
all retainers on the rear of the
switch holder.
148 Locate the brushbar microswitch
onto the two pegs on the holder.
Attach the brushbar microswitch
loom to the switch (red wire onto
the front terminal).
57
To Next Page
Loading...
