53
To the bottom of the battery/lower frame support rods, just below the main gear and behind the battery support/
mount. Use some small strips of foam mounting tape on the rods, and a long cable/zip tie wrap (included in the
“Mounting Accessories & Wrench” package), to secure the ESC in this location. Be sure to also secure the receiver
and battery power leads away from the gears and any other moving parts. Then, depending on the length of the
motor leads, it may also be necessary to make up some short motor wire lead extensions (using approximately
1.5”–2.0” of wire and the connectors included with the ESC) to connect the motor to the ESC.
• After securing the ESC in its mounting position, connect the motor wire leads to the connectors on the ESC.
The order of the wire leads in the connectors is not too important at this time, as any two of them can be
reversed if the motor does not spin in the proper direction after testing its operation.
To Next Page
Loading...
