8
K000000000EJ 023826A0 100714
2.0 SAFETY
2.1 Intended purpose
This chapter describes the areas of application for which the E4500 is intended.
Using the E4500 in other application areas is on the risk of the operator and the manufacturer assumes no
responsibility and liability for loss, damage or costs which could be a result. It is mandatory to read and pay
attention to the operating/maintenance manual.
All products of the series E4500 are handheld measuring devices in professional flue gas analysis for:
• Flue gas analysis & Emissions monitoring for residential, commercial and industrial applications
• Calculating of stack heat loss and efficiency
• CO- and NO environment measurement
• Tightness test
• Store Smoke value, calculating mean value
• Measuring differential pressure
• Draft measurement
• Stack Gas velocity analysis with optional Pitot tube
2.2 Improper use of the product
The
use of E4500 in application areas other than those specified in Section 2.1 "Intended use of the product" is to
be considered at the operator’s risk and the manufacturer assumes no responsibility for the loss damage or costs
that may result. It is recommended to read and pay attention to the instructions in this use and maintenance
manual.
E4500 should not be used:
• For continuous measurements > 1h without performing a fresh AutoZero calibration cycle
• As safety alarm instrument
To Next Page
Loading...
Need help?
General
