Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 41
Module: FUNCTION Function: LOAD ALL
A disk stores Presets, Voices, and Sequences. Load All loads all data on the disk into the Emax.
If a disk is in the drive when the machine is first turned on, Load All is invoked automatically.
Similarly, inserting a disk into the drive right after the machine has been turned on will initiate the
Load All function. At all other times use Load All to transfer disk data into the Emax.
1. Insert the disk to be loaded into the drive.
2. Press LOAD ALL. The display says:
.and the ENTER light will flash.
3. To load all presets and sequences, press ENTER. The display says:
After several seconds, the disk will be loaded and the display will show the Current Preset. If there is
a problem with the disk, the ENTER light will flash and the display will say...
Press ENTER to give it another try. Otherwise, try a different disk.
4. To choose a different Preset enter its number with the keypad (see GENERAL INSTRUCTIONS 1,
“Selecting the Current Preset”).
5. To choose which Current Preset will be active when you load a Bank, select the desired Preset just
before saving the Bank to disk (see PRESET MANAGEMENT 2, “Save All”). The Emax will default to
that Preset whenever you load the Bank.
Module: FUNCTION Function: ENTER DATA
ENTER is a something that Emax, rather than you, activates. Just as you can activate a module to tell
Emax something you want to do, Emax can activate this module to tell you something it wants you to do.
Sometimes the display will ask you for data (i.e., such as keying in a number to indicate a parameter you
want to change). A flashing ENTER LED means that either data is needed to be entered, or another step
is involved in completing a function. Under these conditions, Emax is in a “holding pattern” where you
must enter the desired data, or de-activate the module, before Emax can move on to other functions
(however, you can still play the keyboard).
After keying in the data, press ENTER to send the data into Emax’s computer. If the ENTER LED is lit
steadily, pressing ENTER is optional. Usually this exits you from the function, and kicks you back to the
Module Identifier so that you can go directly to another function within the module.
Load All Presets
nd Se
uences
Just a Moment...
Read Error
To Next Page
Loading...