E-Mu EMAX - Erase Sequence; Rename Sequence

Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 111
2. The display now says:
...where XX is the sequence number selected in the previous step (source sequence), and YY is the
sequence number the loaded sequence will have in Emax’s bank (destination sequence; this defaults
to the first available empty sequence). Use the slider or numeric keypad to select one of the 50
sequences in Emax.
3. Press ENTER after choosing the desired sequence, and the sequence will be loaded. If you haven
chosen to load into a non-empty sequence, the display will prompt you with:
Press YES to overwrite, NO to select a different destination sequence.
4. Once the sequence has been loaded, you have the option to rename it:
Press ENTER if you don’t want to rename; this returns you to the Module Identifier. Otherwise, name
the sequence as described in SEQUENCER MANAGE 6.
Module: SEQUENCER MANAGE 4 Function: ERASE SEQUENCE
This function erases a sequence In the Emax memory. It does not erase a sequence from disk. To
erase a sequence from disk, you must first load the disk, erase the sequence, and then save the
bank to disk (PRESET MANAGEMENT 2).
1. With the Sequencer Manage module active, select 4.
2. The display says:
...where XX is a two-digit sequence number. Use the slider, or numeric keypad to select the
sequences in memory. After selecting the sequence to be erased, press ENTER. The display says:
3. Press YES to erase and return to the Module identifier, or if you change your mind, press NO (Emax
still returns to the Module Identifier).
Load SXX To SY
Y
Select Se
q
uence
Load SXX to SY
Y
Overwrite Y
/
N
Rename Sequence
SXX sequencename
Erase SXX
Select Sequence
Erase SXX
A
re
y
ou Sure? Y/N