Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 73
PRESET DEFINITION MODULE
Module: PRESET DEFINITION 1 Function: COPY VOICE(S)
This function copies Voice(s) from one Preset to another.
1. Activate PRESET DEFINITION 1.
2. The display says:
….where XX defaults to the Current Preset. Select the Preset that contains the Voice(s) to be copied,
then press ENTER.
3. The display now shows:
...where XXX is either Pri, Sec or Both. Use the data slider to select whether you will copy Primary,
Secondary or Both Voices, then press ENTER.
Note: If you select Both, even though the source Preset contains no secondary Voices, you can
overwrite double Voices during the copying process (step 7).
4. The display says:
...where XX defaults to the lowest note of the lowest Voice (whether Pri or Sec). Press the lowest key
of the range you want to copy, or to quickly select the lowest note of the available Voices, use the
data slider. While selecting the low key, the lower display line will show the Voice number and its
original pitch. When the display shows the desired low key, press ENTER. The display now asks you
to choose the Hi Key:
...where YY defaults to the highest note of the previously selected voice. Press the highest key of the
range you want to copy or to quickly select the highest note of the available Voices, use the data
slider. After selecting the range to copy, press ENTER.
5. The display asks:
GetVoice From PXX
Select a Preset
Get Pri, Sec, or
Both Voices :XXX
Lo:XX
Seect Lo Key
Lo:XX -> Hi:YY
Select Hi Key
CopyVoiceTo PXX
Select A Preset
To Next Page
Loading...