Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 44
2. The display says:
Check that a formatted Emax disk is in the drive. If not, insert one. To prevent any embarrassing
errors, write-protect the disk (GENERAL INSTRUCTIONS 4). Press ENTER, there will be a short wait
while Emax loads the formatting software.
3. The display now says:
Remove the source disk and insert the disk to be formatted, then press ENTER. The display will say:
Formatting takes just enough time that you can get a drink of water or do a couple of sit-ups.
(Or something less healthy... - Ed.) After formatting is complete, the display asks:
To format another disk, remove the newly formatted disk from the drive, insert the next disk to be
formatted in the drive, then press YES. Otherwise, press NO, whereupon the display returns to the
Module Identifier.
Module: MASTER 6 Function: COPY DISK
As you build up a collection of disks, remember that they are not indestructible. E-mu
recommends copying (“backing up”) any disk that contains material you don’t want to lose.
Preferably, keep additional backups at a separate location for maximum safety.
Note: Copying data to a disk will erase any data on the disk being copied to.
1. Insert the disk to be copied (“source” disk) into the drive. To prevent any embarrassing
mistakes, make sure it’s write-protected (see GENERAL INSTRUCTIONS 4).
2. Activate MASTER 6. The display says:
Please Insert
Source Disk
Pls Insert Disk
To Be Formatted
Formatting...
Format Another
Disk? Y/N
Copy Disk - Will
Erase Memor
! OK?
To Next Page
Loading...