Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 74
.where PXX defaults to the Current Preset. Select the destination Preset to which you want to copy
the Voice(s), then press ENTER. If you select an empty Preset, upon pressing ENTER you will be
given a chance to rename the Preset that which Emax just created for you. Rename as described in
Preset Management 6. After renaming is complete, press ENTER.
6. The display now shows:
...where XXX defaults to your previous selection in step 2 (note: if in step 2 you selected Both, then
EMAX will automatically go to step 7). This step allows you to copy Primary Voice(s) to Secondary
locations and visa versa. Use the data slider to select whether you will copy the Voice(s) to a Primary
or Secondary location, then press ENTER.
7. The display now says:
....where XX defaults to the previously-selected low key. Press the low key of the desired range in the
destination Preset. The lower display line will show the Voice number and original pitch in the
destination Preset. Attempting to place the low note in such a way that the range cannot be assigned
produces an “Illegal Asgnment” display.
8. After specifying the range’s low note, press ENTER. The display will warn you if this assignment
either modifies the existing assignment or erases (overwrites) any existing Voice(s). If this is okay,
press YES to copy and return to the Module Identifier. Otherwise, press NO to interrupt the copying
process and return to the Module Identifier.
Module: PRESET DEFINITION 2 Function: EDIT ASSIGNMENT
Use this function to change the assignment of a Voice within a Preset.
1. Activate PRESET DEFINITION 2. The display says:
…where XXX is either Pri or Sec. Use the data slider to select whether you will edit the Primary or
Secondary Voice, then press ENTER. If there are only Primary or Secondary Voices, EMAX will
automatically go to step 2.
Copy Voice To
Pri or Sec:XXX
Lo:XX
Move Lo Key
Edit Pri or Sec
Voice: XXX
To Next Page
Loading...