Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 75
2. The display now says:
….where XX defaults to the lowest note of the lowest Voice (whether Pri or Sec). Press a key in the
range of the Voice that you want to edit, or to quickly select the voice, use the data slider. While
selecting the Voice, the lower display line will show the Voice number and its original pitch. After
selecting the Voice to edit, press ENTER.
3. The display now shows the complete assignment:
...where XX are notes and YY is a range of numbers from 1 to 8. Place the new Original note. If the
display says “Illegal Asgnment,” you are doing something like exceeding the transposition limits. Play
a key to select notes, and the cursor buttons to select the desired parameter to be changed. Note:
You can also use the data slider to show the available keys.
To select the output channels (Chs) over which the Voice will appear, move the cursor under the first
Chs number and select the desired value. Then move the cursor over to the second Chs number and
select the desired value. The Voice will appear over all channels between, and including, these two
values. Press ENTER, and Emax will return to the Module Identifier.
Hint: The number of channels assigned = Polyphony of any given voice.
Module: PRESET DEFINITION 3 Function: ERASE VOICE(S)
Use this function to erase a Voice(s).
1. Activate PRESET DEFINITION 3. The display shows:
…where XXX is either Pri, Sec or Both. Use the data slider to select whether you will erase the
Primary, Secondary, Both Voice(s), then press ENTER. If there are only Primary or Secondary
Voices, EMAX will automatically go to step 2.
2. The display says:
…where XX defaults to the lowest note of the lowest Voice (whether Pri or Sec). Press the lowest key
of the range you want to erase, or to quickly select the lowest note of the available Voices, use the
data slider. While selecting the low key, the lower display line will show the Voice number and its
original pitch. When the display shows the desired low key, press ENTER.
Orig Lo Hi Chs
XX XX XX YY
Key: XX
Select a Voice
Erase Pri, Sec
or Both: XXX
Lo:XX
Select Lo Key
To Next Page
Loading...