Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 85
15. The next arpeggiator option is Cruz Control, which fits the number of notes you’re holding into the
specified note value (if you can’t picture this effect, then give it a try and you’ll hear what it does). The
display says:
Use the ON and OFF buttons to select whether Cruz Control is on or off.
Note: Cruz Control cannot be used when either Key Repeats or Glissando are on. Turning on
Cruz Control will simply turn off Key Repeats and Glissando.
16. The next arpeggiator option is Glissando. The display says:
Use the ON and OFF buttons to select whether Glissando is on or off. Glissando will play every
chromatic step between the notes played, including extensions.
17. Last but not least comes the range adjustment. The display says:
This is the default setting and indicates that arpeggiation will occur in the range of A-1 to C7 (the full
MIDI range of notes). Play the key that corresponds to the lowest note in the range you want
arpeggiated (or use the data slider), and then press the RIGHT ARROW key. The cursor will move to
the second note in the display, which now says:
….where XX is the note you just selected. Now play the note that corresponds to the highest note in
the range you want arpeggiated (or use the data slider). The display will confirm your choice; press
ENTER to jump back to the Module Identifier, otherwise press the right arrow cursor button to
continue the setup. Note: Emax will not let you choose a lower note higher than the currently selected
upper note.
Now that the arpeggiation setup is complete, press ENTER to jump back to the Module Identifier. Or,
you can use the cursor keys to go back and change previously selected parameters.
Cruz Control:on
Select on/off
Glissando: off
Select on/off
Range: A-1 to C7
Select Lo Ke
Range:XX to C7
Select Hi Ke
To Next Page
Loading...